Hotspot doesn't show up after install on Commodore CVR-200

[skruehoetl]

Sorry for asking stupid questions - but I ran into an issue on a fresh install of Valetudo on my Commodore CVR-200:

What I did initially:

• I did the install als per the Readme.md
  
• The dustbuild/er firmware I'm using is for the viomi.vacuum.v6
• I rebooted
• I did the "/opt/8821cs/enable_8821cs.sh" step as described and rebooted again

The problem:

• There is no hotspot looking remotely like valetudo (the Android companion app also doesn't find one.

What I did then:

• I disabled/re-enabled the 8821cs module (rebooting in between) - no effect
• I checked for the modules with "lsmod" on adb shell and found "8189es 2023555 0" (with the 8189es and the renamed 8821cs module - except with different sizes (2023555 vs 1542814))
• I looked (stupidly) at the ifconfig output showing me wlan0 uninitialized...
• I tried repeating the install - but that of course didn't work

... please help?

[Hypfer]

Did you also press and hold the two buttons until the robot informs you that Wi-Fi has been reset. as mentioned in the last step of the rooting instructions?

[skruehoetl]

Ahm... That did it. Thanks. I must have skipped those lines (which is more than a bit embarrassing). Anyway - huge thanks for helping!