Using an ESP32-CAM I cannot get the LED turned off

[kongomongo]

hi there, when I setup ems-esp32 using the ESP32-CAM hardware everything worked perfectly. Initially I tried using the onboard LED Flash in the pin setup. However now the flash is too bright and constantly on so I tried removing that setting. But the LED continues to be on and I can't get it to turn off even with rebooting. Is there anything I can do to set the GPIO to 0?

[MichaelDvP]

If you change the LED pin, the old pin stays at same state., also on a reboot. You can

• change led port to 0, then power cycle the esp32, then the old led goes to default
• or confgure the led port, select invert led and after led goes off, reconfigure the led port to 0.

[kongomongo]

solution 2 worked! Thank you so much!