Add ^MN (Media Tracking) command

[itsmattking]

Media Tracking

This command allows to set continuous mode for receipting, auto detect for labels, etc.

Format: ^MNa,b

a = media being used

• Values:
  • N = continuous media
  • Y = non-continuous media web sensing1, 2
  • W = non-continuous media web sensing,1, 2 M = non-continuous media mark sensing
  • A = auto-detects the type of media during calibration1, 3
  • V = continuous media, variable length4
  • Default: a value must be entered or the command is ignored

b = black mark offset in dots

• This sets the expected location of the media mark relative to the
  point of separation between documents. If set to 0, the media mark
  is expected to be found at the point of separation. (i.e., the perforation,
  cut point, etc.) All values are listed in dots. This parameter is ignored
  unless the a parameter is set to M. If this parameter is missing,
  the default value is used.

• Values:

  • 80 to 283 for direct-thermal only printers -240 to 566 for 600 dpi printers
  • 75 to 283 for KR403 printers
  • 120 to 283 for all other printers
  • Default: 0