Powerstream values stuck during the night

[digitaldeceiver]

I have the problem that during the evening when the attached Delta 2 station reaches its lower charge limit (30%) it apparently will shut off power to the Powerstream, this causes the values to become "stuck" at whatever values the PowerStream had at shutdown. For instance I am feeding the full 600W into the AC output and when it's out, the value will stay there, then in the morning when the PowerStream wakes up again Home Assistant takes this value and applies it to the last 12 hours or so, suddenly having an output of something like 7kwh. Is there a way to reset the values when the PowerStream goes offline to avoid ruining the statistics?

Thanks!

[matajumotors]

I have the same with PowerStream. Device status does however go to appears_offline but would be good to 0 all reading or NA.

[myroslav]

Isn't this issue the same as #405 and #406?

[matajumotors]

You are right, maybe it is the same cause as for 406. Not sure about as 405 as that describes receiving a single reading after connection only.