-
Notifications
You must be signed in to change notification settings - Fork 380
FAQ
Hi, i setup it using git clone then iam trying to run it but i do not know why or what should i do next. Any help about the next steps to run it ?
No
The info section of afrog's PoC format is borrowed from nuclei, while the rest is more heavily influenced by xray.
No
The PoC formats of afrog and xray are similar, especially in the rules section, which is almost interchangeable. However, the info section in afrog and the details section in xray are different and would benefit more from borrowing the format of nuclei.
If the command 'afrog.exe -update' is executed, the following error may occur:
Error Info
[FTL] could not install latest release: looking up path of "afrog.exe": exec: "afrog.exe": cannot run executable found relative to current directory
How to solve the above problems?
Need to add afrog.exe to the environment variable.
To add afrog.exe to the environment variable in Windows, you can follow these steps:
1. Right-click on "This PC" and select "Properties".
2. In the left pane, select "Advanced system settings".
3. Click on the "Environment Variables" button.
4. Under "System Variables", find "Path" and double-click to edit.
5. Click the "New" button and enter the path where the afrog.exe file is located.
6. Click the "OK" button to save the changes.
7. Close all open windows, reopen the command prompt, and type the "afrog" command to test if the addition was successful.
To add afrog to the environment variable in Linux/macOS, you can follow these steps:
1. Open the Terminal application.
2. Enter the command: sudo nano /etc/paths.
3. Add the following line to the end of the file: /path/to/afrog, where /path/to/afrog is the path to the afrog file.
4. Save the file and exit the editor.
5. Enter the command: source /etc/paths to update the configuration.
6. Enter the command afrog to test if the addition was successful.
7. Note that if you are using a different shell, such as bash or zsh, you may need to edit the corresponding configuration file (e.g., ~/.bashrc or ~/.zshrc) and add the appropriate path.